本文发表在 rolia.net 枫下论坛市面上有两种cv-boot,一种是整体的(solid/universal),一种是splited,价钱都在十几二十几。前者换起来不是那么容易,必须把cv-joint卸下来,一般需要一些专门工具,但是使用时间比较长。后者基本是只要能够卸轮子,就可以自己换,但由于是溶解胶合的,使用时间一般1-2年,在气候严酷的地方使用时间还要短。
这里介绍一下以前换splited cv-boot的简单经过:
1.loose the lug nut.
2.jack car by a jackstand.
3.get the wheel off
4. turn the steer to the dead-end that let you can easy see the cv-joint.
5.raise the low-bowl joint use a jack, let the drive-axle level.
6.get the old boot off the cv-joint
7.use high-pressure water(后院浇花的水管用指头压压的水压都可以), completely clean the cv-joint inside, let the old grease and dirts out, (边清洁边转动轴会比较容易清洁干净)
8.use wd-40 to clean it again, due to let the water out, then wait till them dry.
9.then do as your cv-boot's guide say,比较剪裁boot大小,在cv-joint 里注满grease,在boot上涂溶解济,安装,晾干,上大小clamps。
10.特别小心clamps的用法,不然可能不牢固。
11.low down your low-bowl joint, put your wheel back.
then, ok.
good-luck.更多精彩文章及讨论,请光临枫下论坛 rolia.net
这里介绍一下以前换splited cv-boot的简单经过:
1.loose the lug nut.
2.jack car by a jackstand.
3.get the wheel off
4. turn the steer to the dead-end that let you can easy see the cv-joint.
5.raise the low-bowl joint use a jack, let the drive-axle level.
6.get the old boot off the cv-joint
7.use high-pressure water(后院浇花的水管用指头压压的水压都可以), completely clean the cv-joint inside, let the old grease and dirts out, (边清洁边转动轴会比较容易清洁干净)
8.use wd-40 to clean it again, due to let the water out, then wait till them dry.
9.then do as your cv-boot's guide say,比较剪裁boot大小,在cv-joint 里注满grease,在boot上涂溶解济,安装,晾干,上大小clamps。
10.特别小心clamps的用法,不然可能不牢固。
11.low down your low-bowl joint, put your wheel back.
then, ok.
good-luck.更多精彩文章及讨论,请光临枫下论坛 rolia.net